Challenge of Day

Friday, December 12, 2008

The component or application containing the component has been disabled

Hello,
In continuing our journey to deploy COM+ object developed under PowerBuilder 10.5 we encountered anouther problem.
Problem: The COM proxy is on S1. The COM is deployed on S2. When we try to access the COM from S1 we get this error message:
Code 80004027 The Component or Application Containing the Component has been Disabled

Remedy:
1 - The server may has not been setup correctly because COM+ is not enabled. To Enable Network COM+ Access do the followings:
o Click on Start, go to Control Panel -> Add Remove Programs -> Widnows Compnents
o Select Application Server and click on the Details
o Click Enable Network COM+ Access and the click OK.
Remember you might need Windows Installation CDs

2 - Make sure that by using DCOMCNFG you give enough permision to applications.

Be a winner in your daily challenges
Ali Khademi
Technical Documents: http://www.khademi.com/document/docs.htm


2 Comments:

At September 29, 2010 at 7:06 PM , Blogger jackob said...

Hi,
I was searching the Internet and found your awesome blog. I have studies many PowerBuilder books on the market,If read your this site this is very informative, and your site gives planty of knowledge about PowerBuilder.
Thank You

 
At May 19, 2011 at 12:40 PM , Anonymous LarryP said...

I had a similar problem with a proxy component. Turns out on the server the component was installed on, 'Enable Network DTC Access' was not checked under Application Server.

 

Post a Comment

Subscribe to Post Comments [Atom]

Links to this post:

Create a Link

<< Home